series 1-dcl ? optically coupled mosfet output ? ratings from 7a to 40a @ 200 vdc, and from 7a to 10a @ 500 vdc ? dc control ? relays are easily paralleled for higher-current applications product selection load voltage 7a 10a 12a 20a 40a 100 vdc D1D07L d1d12l d1d20l d1d40l 200 vdc d2d07l d2d12l d2d40l 400 vdc d4d07l d4d12l 500 vdc d5d07l d5d10l output specifications (1) description 7a 12a 20a 40a 7a 12a 40a 7a 12a 7a 10a operating voltage range 0-100 0-100 0-100 0-100 0-200 0-200 0-200 0-400 0-400 0-500 0-500 maximum off-state leakage current @ rated voltage [ma] 0.1 0.2 0.3 0.3 0.1 0.3 0.3 0.3 0.3 0.2 0.3 maximum load current (3) [adc] 7 12 20 40 7 12 40 7 12 7 10 minimum load current [ma] 1 1 1 1 1 1 1 1 1 1 1 maximum surge current [adc] (10ms) 15 28 42 106 22 27 106 17 36 19 29 maximum on-state voltage drop @ rated current [vdc] 2.0 1.6 2.1 2.1 2.0 2.8 2.1 4.2 4.2 5.7 5.5 thermal resistance juncti on to case (rjc) [c/w] 2.2 1.34 1.06 0.83 1.5 1.06 0.83 1.06 0.8 1.0 0.8 maximum on-state resistance [rds-on][ohms] 0.29 0.13 0.10 0.05 0.29 0.23 0.05 0.6 0.35 0.8 0.55 input specifications (1) description control voltage range 3.5-32 vdc minimum turn-on voltage 3.5 vdc minimum turn-off voltage 1.0 vdc minimum input current @ 3.5v 8.4 ma maximum input current @ 32vdc 10.6 ma nominal input impedance see note 4 maximum turn-on time [msec] 1.0 maximum turn-off time [msec] 1.0 general specifications description parameters dielectric strength, input/output/base (50/60hz) 2500 vrms minimum insulation resistance (@ 500 v dc) 10 9 ohm maximum capacitance, input/output 50 pf ambient operating temperature range -40 to 80c ambient storage temperature range -40 to 125 c weight (typical) 3.0 oz (86.5g) encapsulation thermally conductive epoxy terminals screws and saddle clamps furnished, unmounted recommended terminal screw torque range: 6-32 screws - 10 in lbs. 8-32 and 10-32 scre ws -20 in. lbs. (screws dry without grase) general notes 1) all parameters at 25c and per section unless otherwise specified. 2) dielectric strength and insulation re sistance are measured between input and output 3) heat sinking required, fo r derating curves see page 3. 4) input circuitry version incor porates active current limiter.
mechanical specifications thermal derate information
wiring diagram maximum surge vs duration agency approvals designed in accordance with the requirements of iec 62314 e116950 (100 and 200v models except d2d40l) rev. 120811
annex - enviromental information
|
